Yash Jasnani

I have strong interest and orientation towards design and analysis of electronic circuits,

embedded systems and IoT based systems. I have good hands on Lab experience in handling many instruments and designing, testing and analyzing the circuits and systems.

Embedded System Engineer

SuperFoam Dia Tools, Udaipur

Designed embedded hardware, firmware and interface for Oxygen Concentrator

Machine using Atmega328p, which controls 3 SSR using timer interrupt, A OCS-3F3.0

Ultrasonic Oxygen concentration sensor using UART protocol, A 1.3' OLED Display using I2C protocol, Some Digital logic Sensors like Over voltage detection sensor,

Temperature Sensor, A high pressure detection sensor, A power failure detection, And a Buzzer which Beeps when oxygen concentration is below 60%. OLED display shows information of Oxygen Concentration, Fault in machine, Total run time of machine which is stored in EEPROM.

Test Product Engineer (R&D)

Integrated Power Solutions

My role was to develop and execute comprehensive test plans, assemble and test prototype SMPS boards (AC-DC, DC-DC) and LED Drivers, Troubleshooting and Repairing of rejected lots under warranty and Support R&D Team.

I used to perform a Surge test up to 4KV, note under and over voltage cutoff values as well as Power Factor (PF) and THD values and perform burn-in tests for 78 hours and document these test results.

Bachelor of Technology

Electronics & Communication Systems

Techno India NJR Institute of Technology