Rohithvarman A

I am an Aeronautical Engineering graduate (HITS Chennai, CGPA 8.46) specializing in CFD simulation and UAV aerodynamics. Proficient in ANSYS Fluent, ANSA Meshing, and CATIA V5 with a DGCA Remote Pilot Certificate from Garuda Aerospace and industrial training at HAL Aircraft Division, Bengaluru. Passionate about drone R&D and aerospace CFD research.

Drone Pilot Trainee - Garuda Aerospace

(2025-06)

• Completed DGCA-certified Remote Pilot Training covering regulatory frameworks, UAV operational safety, and compliance procedures for Small Category drones (<25 kg).
• Registered and operated drones through India's Digital Sky platform in full compliance with DGCA airspace regulations.
• Gained practical experience in flight log maintenance, battery management, and payload integration per DGCA norms.

FPV Pilot Trainee - Chennai Drone Academy

(2025-05)

• Completed FPV drone pilot training using a VR-based simulation system.
• Practised Angle Mode (stabilised flight) and Acro Mode (manual freestyle flight).
• Developed advanced aerial manoeuvring skills and manual flight control proficiency across varied flight conditions.

Industrial Training Intern - Hindustan Aeronautics Limited (HAL)

(2024-12 - 2024-12)

• Gained in-depth exposure to fuselage integration, wing assembly, landing gear systems, cockpit canopy, and pilot seating systems.
• Interacted with engineers from aerodynamics, structures, propulsion, and aircraft design teams.
• Developed understanding of industrial-grade aerospace manufacturing workflows, quality control, and safety practices.

Aircraft Maintenance Intern - Sky Aerospace

(2024-01 - 2024-01)

• Gained hands-on experience in aircraft maintenance, inspection, and servicing procedures.
• Assisted in routine maintenance checks and aircraft system inspections.
• Developed understanding of aircraft maintenance protocols and safety standards.

Drone and RC Aircraft Engineering Intern - Skyrider Aerosolutions

(2023-07 - 2023-07)

• Built a drone and RC plane from scratch including frame assembly and component integration.
• Configured flight controllers and transmitters for drone and RC plane operations.
• Understood integration of motors, propellers, Electronic Speed Controllers (ESC) and flight controllers.
• Gained hands-on experience in drone electronics, wiring and calibration.

B.Tech - Aeronautical Engineering - HINDUSTAN INSTITUTE OF TECHNOLOGY & SCIENCE (HITS) (2022 - 2026)

Higher Secondary Certificate (HSC) - VELAMMAL BODHI CAMPUS MADURAI (2022 - 2022)

Secondary School Leaving Certificate (SSLC) - RAJA MATRIC HIGHER SECONDARY SCHOOL (2020 - 2020)