Vamsi Haradeep

Project engineer

Talent

Kākināda, East GodavariMember since June 6, 2023

Hire this person

Send a job offer directly to this candidate

About

Working as a Project engineer in the operation, inspection, and repair of Capital Drilling Equipment (Marine Risers, Telescopic joints, and co-flex hoses).

Experience

Working as a Project engineer in the operation, inspection, and repair of Capital Drilling Equipment’s (Marine Risers, Telescopic joints, and co-flex hoses).
Physically participate in carrying out processes to gain a fundamental understanding of them and doing draft procedures as required report effectively to management and Customers.
Working in various clients VANTAGE, SPC-QGOG, UNIVERSAL, TRANSOCEAN knowledge in Acker clip type risers, Cameron R/F type risers and NOV R/F type risers and Telescopic joints.
Knowledge in precision Measuring equipment’s (OD micrometer, ID micrometer, Depth gauge and seal grooves measuring equipment, Verniers)
Performed the Borescope inspection / Repair on Co-flex hoses and hydraulic hoses.
Knowledge in weld repairs of Marine risers and Telescopic joints.
List of equipment’s and other devices to be used were calibrated and calibration certificate has been provided prior to usage.
To carry out Pre, during and post welding inspection activities.
Pre welding activities like check, review and verifying the applicable code, standards, or specifications to be implemented on the job is up to date with latest revision or amendment.
Joints to be welded should comply with approved WPS requirements like joint design, root gap, rot face, bevel angle, pre heat (if any).
To check, monitor and record the voltage, amperage & travel speed for the runs in order to control the heat inputs on the weld joint.
To check, root penetration, imperfections, defects, surface cleanliness of each runs.
After welding, weld cleanliness, weld face, weld height to be checked as per acceptable standards.
If any defects are observed, repairs to be carried out with approved repair procedures.
To carry out the necessary NDT activities for further verification.
If PWHT is required, it should be monitored and recorded.
If pressure test is required, it should be monitored and recorded.