QA/QC INSPECTOR (STRUCTURE), YONGNAM ENGINEERING SDN BHD, MALAYSIA
JAN 2019- PRESENT
PROJECT: JTC WOODLANDS NORTH COAST, SHIMANO, ROCHESTER PARK, PUNGGOL
- Reviewed ITP (Inspection Test Plan), Inspection Requirement project
- Checked and witnessed Fit-up Inspection and Dimension inspection before weld
- Perform Visual inspection according to project standard
- Conducted WQT, Pre Qualified Welder Test
- NDT (Non Destructive Test) – Identified, Monitoring, Review Reports – MPI / UT
- Liaise with fitter supervisor for Dimensional Check of levelness, straightness, tolerance based on spec and project procedure
- Conducted inspection and liaise with ITA, RTO and Client
- Highlighted on Quality Issue such as NCR (Non-Conformance Report), Quality Summons to production department
- Compiled and produced fit-up inspection report, visual inspection report and NDT report
- Produced manufacturer data record and Inspection release note for releasing product
- Update all daily report (MVR, FIT-UP, VISUAL AND NDT)
- Final Documentation Reviewed for completion of project
QC INSPECTOR (PIPING), ROTARY ENGINEERING LIMITED, SINGAPORE
DEC 2017 - NOV 2018
PROJECT: TANK FARM 5 PROPYLENE BULLET TANK STORAGE AND ITS FACILITIES OILTANKING
- Identified documentation- project specs and code, project procedures, pipe and instrument diagram drawings, project standards
- Reviewed ITP (Inspection Test Plan), Inspection Requirement project
- Monitoring and inspection Storage Raw Material, Valve Consumables
- Site Inspection based on procedure and project spec before, during and after weld
- Monitoring and Inspection during Fabrication and Installation
- Conducted WQT, Pre Qualified Welder Test
- Material Receiving Inspection – document, cert, visual inspection based on spec
- NDT (Non Destructive Test) – Requested, Monitoring, Review Reports – MPI / RT
- Monitoring Work Progress to meets planning schedule of project planning
- Check pipe identification, size, code and standard before weld
- Inspect fit-up condition such as bevel preparation, bevel type, mismatch, root gap, root face, cleanness & alignment according specification acceptance criteria
- To monitor welding process to ensure every parameter are according to approved WPS
- Conduct Testing and liaise with third party – Hydro Test, Leak Testing, Service Test, Air Blowing Test, Flushing test
- Inspect valves as per P&ID drawing and isometric
- Line check refer as P&ID drawing and isometric
- Witness Hydrostatic test, flushing and air blow
- Update all daily report (MVR, FIT-UP, VISUAL AND NDT)
- Updating Drawing as built drawing, Red Line Drawing, Mark Up Drawing, STQ latest issue drawing, update with any site modification
- Final Documentation Reviewed for completion of project
NDT TECHNICIAN, ENERGY WORKFORCE SDN BHD, PENGERANG MALAYSIA
JULY 2015 - NOV 2017
PROJECT: PETRONAS RAPID BULLET TANK(DFPF)
- Perform Assistant Phase Array Ultrasonic Testing
- Perform Hardness Test (VICKER and BRINELL)
- Perform Magnetic Particle Inspection and evaluate the defects
- Perform Dye penetration inspection and follow procedure given by level III
- Quality control will determine and communicate which parts will be inspected.
- Calibrated NDT tools such as magnetic yoke current and effectiveness to find any defect
- Perform after repair inspection
- Review PAUT, HT and MPI procedure
- Produced and submitted report for HT, DPI and MPI
- Communicated and follow up with level III if any problem with work or reporting
