Dotun Shegs

An experienced field engineer adept with providing technical engineering support; very flexible and can handle customer support, pre-sales and post sales initiative which involve installation, modification of power plant automation and control systems; has an advanced knowledge in planning and development and has experience in preparing of blueprints, recommending schematics, designs, specifications and electrical drawings; can adapt well with equipment changes and can satisfy client’s unique requirements; results-oriented and a go-getter.

An experienced field engineer adept with providing technical engineering support; very flexible and can handle customer support, pre-sales and post sales initiative which involve installation, modification of power plant automation and control systems; has an advanced knowledge in planning and development and has experience in preparing of blueprints, recommending schematics, designs, specifications and electrical drawings; can adapt well with equipment changes and can satisfy client’s unique requirements; results-oriented and a go-getter.

WORK

EXPERIENCE

Hakman Engineering Ltd. 2008 Field Service Engineer

• Design, commissioning and installation of electrical panel such as; Auto Mains Failure (AMF), Auto Transfer Switch (ATS) and Synchronizing Panel 

• Programming of generator controller, synchronizing and paralleling of gensets (gas/Diesel), turbine with black start commissioning in power plants.
• Trouble shooting and maintenance on low voltage electrical panel.

Electrical Engineer

•  Commissioning and installation of electrical panel such as; Auto Mains Failure (AMF), Auto Transfer Switch (ATS) and Synchronizing Panel using ComAp Controller and Deep Seal Electronic Controllers (DSE)

• Programming of ECU or ECM, Actuator L-Series, Pandaros etc for Speed Bias

• Remodification of Generator modules Software’s

• Repair, Calibrate, Troubleshoot and wiring of control panels 

• Formatting, Downloading and Configuration of new module’s software

• Trouble shooting and maintenance on Low Voltage Cubicle Switchboard 

HND, Electrical Engineering 2018

Lagos state Polytechnic, Ikorodu

OND, Electrical Engineering 2013

Lagos state Polytechnic, Ikorodu.

Diploma in Refrigeration & Air-Conditional 2005 - 2007

Government Technical College Ikotun Lagos

TRAINING

• DSE Training for DSE Modules, DSE Webnet, DSE Scada, DSE PLC and Synchronizing and Load.

• Sedemac Training for Powertrain Controls 

• Training on Air Circuit Breaker (ACB) and Molded Cases Circuit Breaker (MCCB) using ABB, TERASAKI, SCHNEIDER and LS for simulation.

• Terasaki specialist training on trouble shooting, repairs, retrofitting, Installation, testing, relay calibration, commissioning etc on Terasaki AH, AT, AP, AR series switchgears and control systems 

• DEIF Training for DEIF Modules, DEIF Automatic Mains Failure(AMF), Auto Transfer Switch(ATS) and Synchronizing and Load.

• ComAp Training for ComAp Modules, Programming of ComAp Modules such like, Remote Display Module, Single Gen Set Controller Module, Engine Controller Modules, Master Controller Modules and Paralleling Gen Set Controller Modules 

Member; Association of Electrical/Electronic Engineering Students.SKILLS

• Creative and Analytical Thinking.
• Negotiation and Team Management
• Computer Application (MS Office Suite). AutoCAD
• Detail Oriented and Problem-solving skills.
• Good Verbal and Written Communication skills.

• Interpret electrical system diagrams
• Ability to perform complex electrical problem and trouble-shooting of fault in any control panels. 
• Ability to read and interpret schematics wiring diagrams.
• Design power and control schematic diagrams

• Reading.
• Traveling.
• Foot Ball.