Fatima Nina Lopez

To apply in any desirable related job or position available in your good company which will further my experience.

Technician, Material Verification and Control PM4 - Collins Aerospace

(2021-10)

• Works under direct supervision to assist with inspecting arriving, inprocess and completed products for quality.
• Performs basic in-process, final bench and product feature inspections.
• Performs basic First Article Inspections (FIA) and conformity inspections.
• Inspects actual products on the floor and on-line.
• Gathers data for preparation of technical reports.
• Gathers data to prepare inspection and test plans, standards and acceptance criteria, and procedures/work instructions.

QA Specialist - COHU DELTA PHILIPPINES

(2020-02 - 2021-10)

• Inspect incoming materials, fabricated/ subcontracted materials and other related device for conformance to requirements.
• Analyze result of inspection and provide feedback to related department for improvement.
• Prepare CMM program for new parts / design.
• Prepare set-ups utilizing precision measuring instruments to verify all types of measurements.
• Report all relevant issues to QA Supervisor and QA Manager on a timely manner.
• Interact with various department supervisors to identify and resolve issues. Provide input regarding the disposition of non-conforming units or materials.
• Utilizing computer software in recording inspection data.
• Ensure inspection traceability by properly recording result of inspection either by hard copy or soft copy.
• Conduct quality audits.
• Perform other duties and responsibilities that may be assigned.

In-Process Inspector /CMM Programmer - Advance Machining Corporation (Aerospace)

(2017-10 - 2020-01)

• Inspecting output samples using industry-appropriate methods, such as comparing to standards, measuring dimensions and examining functionality.
• Checking that the assembly or production line adheres to standards and procedures and complying with legal requirements.
• Reviewing blueprints and specifications to compare to produced goods.
• Recording inspection results by completing reports, summarizing re-works and wastes and inputting data into quality database.
• Monitoring the use of equipment to ensure it is safe and discard any that do not meet requirements.
• Keeping measurement equipment operating accurately by following calibration requirements and calling for repairs.
• Reading and interpreting engineering drawings and radiographs.
• Using gauges such as calipers and micrometers to measure products.
• Verifying all equipment is calibrated correctly.
• Prepare CMM programs as required to CAD data and or prints for component parts and assemblies.
• Performs first off, in-process & end-of-run report.
• Performs ballooning of customer prints/drawings.
• Performs layout of checking fixtures.

B.S - INDUSTRIAL ENGINEER - MANUEL ENVERGA UNIVERSITY (2024-05)

Information and Technology - Mind and Integrity College (2016-04)