Electrician at The Premier Group (2025-06 – Present)
- Bend and run ¾ inch pipe from box to box
- Prefab racks
- Put fire retardant putty on boxes
- Uninstall boxes
- Install Junction boxes and lights
- Run copper wire for lightning rods
Skilled Laborer at Icon Build
Use a tablet to 3D print military barracks at Fort Bliss in El Paso.
Electrician at Century Fire Protection (2025-12 – 2026-01)
Run fire alarm wire for a clinic being built in Round Rock.
Construction Worker at Tidy (2025-10 – 2025-11)
Work with guys sweeping, taping doors, and other miscellaneous activities at the massive Samsung semiconductor plant in Taylor, Texas so they can become acclimated to massive construction projects and then become electrician apprentices.
Electrician Apprentice at Rosendin Electric (2025-05 – 2025-10)
- Bend 90's for ¾, 1, and 1 ¼ pipe
- Bend offsets and kick a 90
- Terminate a disconnect and install an interior panel
- Hang boxes and use the Hilti Gun to shoot a Hilti anchor into the ceiling
- Apply pipe strapping code requirements: strap below 3 feet of pipe at the box, then every 8 feet of pipe
- Use standoff straps, strut straps, and 1-hole straps
- Install boxes every 270 degrees of bend
- Install a shotgun bracket and 1-hole strap pipe to it
- Install boxes in the wall and hang them off the ceiling with all thread
- Use ¼ all thread and 3/8 all thread
- Measure and cut pipe with deductions for 90 bends: 6 inches for ¾ pipe, 8 inches for 1 inch pipe, 11 inches for 1 ¼ pipe
- Perform star bend and bend it backwards for measurements over 5 feet
- Run pipe with couplings and standoff straps facing the same direction
- Ensure all screws face the same direction
- Take measurements for all thread sizing
- Use a one hole saw to saw through metal for pipe installation within stud
- Install connectors in a box and tighten with channel locks while maintaining proper screw direction
- Pull wire and tape it with electrical tape
- Install pig's tail when installing boxes
- Run and feed wire through pipe with one ground per pipe