Technical Specialist - Cardington Yutaka Technologies - Cullman, AL
(2008)
- Machine, lathe, & mill operator
- Final Inspector for production parts for Honda of Lincoln, AL
- Repaired sub comp parts using Mig Welder
- Clean Room assembly
- Final comp inspections prior to shipment to Honda Precision Parts of GA
- Macro Weld Inspection on laser welders and Mig parts per blueprint
- Collecting data and input to Excel spreadsheets, Paxit and Therefore software
- VHX 7000 Ultraprecise Microscope for part inspection
- Issuing gauges for gage and calibration
- New Hire training packet check-offs for Safety Procedures, Scrap Processes, Preventative Maintenance, and part inspection
Inspector/Technician/Operator - Webb Wheel Products - Cullman, AL
(1998 - 2008)
- Running Natco Drill to drill parts to blueprint spec
- Running Hub Lathes and Okuma Mill centers to machine hubs to meet blueprint specs
- Performed visual inspection, inspection using process check sheets
- Brake drum machining and inspection for over 20 machines
- Calibration on gauging such as micrometers, pin mics, outside gauges, and height stands to check bores, wheel and drum pilots, anything within critical limits of 0.003 of an inch or less
Flight Deck Crew/Inspector - United States Navy - Norfolk, VA
(1994 - 1997)
Stationed in Norfolk, VA but had two 6-month deployments on U.S.S. Nassau and U.S.S. Theodore Roosevelt.
- Chocking and chaining aircraft to pad eyes on deck
- Wing Man Inspector for aircraft mobilization on flight deck-this involved much attention to detail due to safety concerns
- Certified Landing Signalman and enlisted in Flight School for certification in use of hand signals for communication with pilots and deck crew
- Worked in Aircraft Intermediate Maintenance Dept. to inspect, repair, or replace batteries and generators on aircraft
