Janitor at Sodexo (2024-07 – Present)
- get the trash from all assigned areas.
- sweep and mop cafeteria and clean restrooms replace toilet paper and paper towels.
- Clean offices sweep and mop them throw trash away also.
- Clean the windows from the offices also.
Janitor/Maintenance at Select Staffing (2023-07 – 2024-06)
- Clean sinks, toilets, and mop restroom floor's.
- Clean break room and microwaves sweep and mob break room.
- Throw trash away from offices break rooms and restrooms.
- Clean outside areas of establishment blow leaves, cut grass, water palm trees.
Water Jet Operator at TORAY (2023-04 – 2023-07)
- Turn machine on computer, log in select program that needs to be ran.
- Load panels onto the machine make sure they line up to stops.
- Make sure to adjust the machine to size as specified on traveler according to size.
- Start machine run one part stop after first part take it to get inspected for first article.
- When done unload reload start machine and start pulling parts off panels.
- Blow off parts with air hose place in bins when order done sign off on them in computer.
- Take to shipping and start next order.
Machine Operator at SALSA PROTOTYPE (2023-01 – 2023-04)
- I load parts onto machine to get production going.
- Check parts as they're being done to make sure part measurements are coming out according to blueprint.
- Saw cut raw material for the work orders.
- Would unload materials from truck with forklift.
- Load trucks with finish parts once wrapped.
Machine Operator at HYPER TECH (2017-09 – 2023-01)
- I work on Haas mills and fadal I also run Doosan with fanuc control lathes.
- I load parts check measurements on parts to make sure there what's on blueprint.
- I work with calipers, Od mics, high gages.
- Make adjustments on offsets when needed change tools and touch them off also when needed.
- Would unload materials from trucks with forklift and put them were they belong.
Dishwasher at Winchester Bar and Grill (2017-10 – 2018-08)
- I would collect all the dirty dishes from all the stations.
- Rinse them off and scrub them and wash them.
- Then I would dry them off and put them back to the area where they went for the cooks to grab them.
Machine Operator at CUTTING-EDGE (2015-07 – 2017-09)
- I would start up the machines in the morning and reference them.
- Run production and make sure measurements are good.
- I have knowledge using calipers, micrometers, height gage, and depth mics.
- Worked on okuma lathes and mills also doosan lathes and toyoda mill with fanuc controls.
- Make sure all machines had there oils and coolant.
Sandblaster/Painter at GENERAL MAGNA-PLATE (2013-07 – 2015-06)
- Would sandblast all parts that need to get sandblaster before they would get either nickel plated or anodized.
- Polish all the parts coming out of getting electro polished.
- I would also paint parts and spray clear coat on some parts as specified.
- Then put them in oven at temperature that parts need to cure.
Machine Operator at HAAS AUTOMATION (2011-08 – 2013-07)
- Worked on Haas machines and Mori seiki machines.
- Run production and check the tolerances.
- Check inserts on rougher tools, check endmills, and make sure drills or taps didn't break.
- Get new offsets on tools that I would replace.
- Check parts using mics, depth mics, and calipers.
- Check the coolant and oils.
