Ilias
Civil Engineering graduate with hands-on construction and academic project experience in aviation infrastructure, bridges, stormwater management, transportation, and utility system
Hire this person
Send a job offer directly to this candidate
About
Civil Engineering graduate (BS, NJIT, GPA 3.5, May 2024) with hands-on construction and academic project experience in aviation infrastructure, bridges, stormwater management, transportation, and utility systems. Skilled in AutoCAD Civil 3D, ArcGIS, Bluebeam, cost estimating, construction observation, inspections, and materials testing. Bilingual in English and Arabic.
Seeking to contribute technical design, fieldwork, and project coordination skills to support civil infrastructure and aviation projects.
Experience
Independent Construction Work - Self-employed
(2019)
- Performed hands-on cement mixing, concrete placement, reinforcement installation, and formwork for small-scale structures.
- Supported site preparation and applied safety protocols and quality control practices.
- Gained practical exposure to bridge-related tasks such as rebar tying and deck concrete finishing.
Senior Capstone Project – Stormwater Drainage System Design - New Jersey Institute of Technology (NJIT) - Newark, NJ
(2024-01 - 2024-05)
- Designed a stormwater drainage system to mitigate urban flooding using Civil 3D.
- Conducted hydraulic analysis, cost estimating, and CAD modeling of system alternatives.
- Delivered written report and oral presentation to faculty and industry reviewers.
Bridge & Structural Engineering Project - New Jersey Institute of Technology (NJIT) - Newark, NJ
(2023-09 - 2023-12)
- Completed structural analysis and preliminary design of a short-span concrete bridge.
- Applied AASHTO LRFD guidelines for load calculations and reinforcement design.
- Produced AutoCAD drawings and engineering documentation.
Transportation Engineering Project - New Jersey Institute of Technology (NJIT) - Newark, NJ
(2023-01 - 2023-05)
- Conducted traffic counts, roadway alignment design, and intersection analysis.
- Proposed signal optimization and roadway redesign to improve safety and capacity.
- Performed calculations and prepared technical documentation.
Structural Materials Testing Lab - New Jersey Institute of Technology (NJIT) - Newark, NJ
(2022-09 - 2022-12)
- Tested concrete, soil, and steel specimens for strength, durability, and compaction.
- Applied ASTM and ACI standards for laboratory procedures.
- Prepared technical reports with analysis and recommendations.
Hydraulic Design Project - New Jersey Institute of Technology (NJIT) - Newark, NJ
(2022-01 - 2022-05)
- Modeled water distribution systems using EPANET software.
- Conducted pipe sizing, pump curve analysis, and pressure zone evaluations.
- Recommended system improvements for cost efficiency and performance.
Education
Bachelor of Science - Civil Engineering - New Jersey Institute of Technology (NJIT) (2024-05)
