Saif Emad

Electrical Power Engineer with hands-on experience in aviation and industrial power environments, including aircraft avionics and electrical systems, power generation, electrical distribution, and preventive maintenance. Experienced in troubleshooting, fault isolation, EWIS inspection, generators, MCCs, switchgear, transformers, PLC/SCADA environments, and engineering documentation. Focused on safety, reliability, technical accuracy, and efficient problem solving in operational settings.

Avionics Engineer (B2) at Joramco (2025-09 – 2026-04)

• Worked on Airbus A320 family, A330, A340, A350, Boeing 737, 747, 777, 787, and Embraer E-Jets.
• Performed daily operational checks, inspections, maintenance, and functional testing of avionics systems including communication, navigation, flight control, monitoring, and cockpit systems.
• Conducted troubleshooting and fault isolation using AMM, wiring diagrams, maintenance manuals, and electrical test equipment.
• Completed EWIS inspections, wiring checks, functional tests, and pre-departure system checks to support airworthiness compliance.
• Resolved complex avionics faults, including a critical Boeing 777 cooling fan control system issue prior to departure.
• Used multimeter, megger, pitot-static tester, resistance loop tester, and programming tools.
• Followed Airbus, Boeing, and internal maintenance manuals and procedures; also served as Safety Representative (Safety Rep).

Electrical Power Engineer - Industrial Training at Qatrana Cement Company / Wartsila On-Site Power Station (2024-06 – 2024-09)

• Completed integrated training in industrial electrical systems and on-site power generation within Qatrana Cement Company and its Wartsila power plant.
• Gained hands-on exposure to power generation, transmission, and distribution using 7 MW HFO/diesel generators and a 1.5 MW emergency/blackout generator.
• Worked with MCC panels, CCR control systems, PLC systems, ACS drives, switchgear, transformers (6 kV / 400-720 V), and high-power motors up to 3.5 MW.
• Supported operation and monitoring of crusher, raw mill, kiln, ball mill, cement, water, and gas station systems to help maintain continuous plant operation.
• Participated in preventive maintenance, troubleshooting, load management, grid synchronization, main bus bar operations, and protection systems.
• Gained exposure to coordination with NEPCO for stable and emergency power supply.

B.Sc. in Electrical Power Engineering – Al-Balqa Applied University - Faculty of Engineering Technology (Polytechnic) (2020-09 – 2025-09)