Aditya

Designed and validated low-voltage electrical architectures for electric commercial vehicles, including connector selection, protection circuits, routing, and detailed From-To documentation. Performed VCU integration, pin mapping, and I/O validation, migrating legacy interfaces to a next-generation controller and debugging subsystem compatibility. Developed and validated CAN communication matrices across the VCU, BMS, motor controller, and instrument cluster for diagnostics, telemetry, and system-level validation.

Electronics Hardware & Systems Engineer Intern at Gray Mobility Pvt. Ltd. (2026-01 – 2026-06)

• Designed and validated low-voltage electrical architectures for electric commercial vehicles, including connector selection, protection circuits, routing, and detailed From-To documentation.
• Performed VCU integration, pin mapping, and I/O validation, migrating legacy interfaces to a next-generation controller and debugging subsystem compatibility.
• Developed and validated CAN communication matrices across the VCU, BMS, motor controller, and instrument cluster for diagnostics, telemetry, and system-level validation.
• Supported vehicle bring-up through electrical debugging, continuity/insulation testing, subsystem fault isolation, and functional verification.
• Assisted with BMS integration and validation, including monitoring of cell-level measurements, temperature signals, SoC, and protection behavior.
• Contributed to EMI/EMC compliance preparation and cross-functional hardware/software debugging during system integration.

Bachelor of Engineering in Electronics & Communication Engineering – BMS Institute of Technology (2023-08 – 2027-05)

Higher Secondary Education in PCMB - Science Stream – Bishop Cotton Boys' School (2021-06 – 2023-05)

Secondary School Education in 10th – Bishop Cotton Boys' School (2009 – 2021-05)